Set 3 remote=$LOGSREMOTE remote-port=4950 Īdd bridge=bridge-inet-HS interface=vlan24-client Īdd bridge=bridge-client interface=ether3-lan-local Īdd bridge=bridge-client interface=vlanID-local Īdd address=”$IPeth5$MASKeth5″ interface=ether5-admin Īdd address=”$IPvlanID$MASKvlanID” interface=bridge-client Īdd address=”$IPinet$MASKinet” interface=bridge-inet-HS Īdd address=”$NETWORKvlanID$MASKvlanID” gateway=$IPvlanID Īdd address=”$NETWORKeth5$MASKeth5″ gateway=$IPeth5 Īdd address=”$NETWORKinet$MASKinet” gateway=$IPinet Īdd action=log chain=forward connection-state=new protocol=tcp src-address=”$NETWORKinet$MASKinet” Īdd action=log chain=forward connection-state=new protocol=udp src-address=”$NETWORKinet$MASKinet” Set enabled=yes trap-community=snmpcommunity trap-version=2 Set enc-algorithms=3des Īdd name=dhcp-pool-admin ranges=$POOLadmin Īdd name=dhcp-pool-client ranges=$POOLclient Īdd name=dhcp-pool-inet ranges=$POOLinet Īdd address-pool=dhcp-pool-admin disabled=no interface=ether5-admin name=dhcp-admin Īdd address-pool=dhcp-pool-client disabled=no interface=bridge-client name=dhcp-client Īdd address-pool=dhcp-pool-inet disabled=no interface=bridge-inet-HS name=dhcp-inet Set idle-timeout=none keepalive-timeout=2m mac-cookie-timeout=3d Set name=ether5-admin Īdd add-default-route=yes disabled=no interface=ether1-wan name=pppoe-out1 password=$ADSLmdp use-peer-dns=yes user=$ADSLlogin service-name=Adsl Īdd interface=ether2-inet-HS l2mtu=65531 name=vlan24-client vlan-id=24 Īdd interface=ether2-inet-HS l2mtu=65531 name=vlanID-local vlan-id=$VLANID #VOUS POUVEZ ENREGISTRER ET RETOURNER SUR LA DOC #VLANID IDENTIQUE NORMALEMENT AU NEW EOIP ID Here is the script (it’s fully commented but in french, sorry i am french eheh but if you know how to use a mikrotik, you will see it’s very simple, and don’t forget to replace the value in the script by yours, like the adsl login etc) : My actual setup works with VLAN, because i use an ALTAI C1 AP with two SSID working on two different VLAN. I will explain here how to configure a mikrotik via a script i made, with radius manager (i won’t explain the radius manager configuration in this post).

DMA Softlabs Radius Manager